Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 59)

Connecting a DC Power Source to an OmniS/R-PS9-DC725
Page 1-29
Inserting the Wire Lead Into the Circular Hole
6. Close the wire bay door. Use the small screwdriver (from Step 4a) to tighten the screw
above the wire bay into which you inserted the wire lead. The wire lead should be
securely attached inside the connector. You should be able to pull on the wire and not
dislodge it.
7. Repeat Steps 4 through 6 for the remaining two wire leads. Be sure that the end of each
lead attaches to the same power source that you connected to on the power supply (i.e.,
ground to ground, positive to positive, negative to negative).
This end would plug into the
ground (GND). The middle
lead would plug into the posi-
tive (+) power source and the
rightmost lead would plug into
the negative (-) power source.
GND/(+)/(-)