Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual
Page 1070
Configuring a Switch with an MPX
Page A-8
8. You can enter an
IP
address for the first hop router to a remote host (if the host is on a
different
IP
net). A screen prompt similar to the following displays.
User
:
9. You can enter a log-in name for a remote host. A screen prompt similar to the following
displays.
Remote password
:
10. You can enter a password for a remote host.
11. A screen prompt similar to the following displays.
Startup script : /flash/mpx.cmd
Enter the command file name or press the
<Enter>
key to accept the default (
mpx.cmd
). A
prompt similar to the following displays.
Console params : 9600,n81c
12. You can change the parameters for the console port. To change the value, enter the baud
rate (
1200
,
9600
, or
19200
, or
38400
), the parity (
n
for none,
e
for even, or
o
for odd), data
length (
7
or
8
), stop bits (
0
,
1
, or
2
), and port type (
c
for console,
s
for
SLIP
, or
d
for
down).
For example,
19200n81c
sets the console port to 19,200 baud, no parity, 8-bit data length,
1 stop bit, and console mode.
♦ Note ♦
If the default baud rate shunt (
E1
) has not been
removed, any changes to the baud rate you enter will
be ignored and a message to that affect is displayed
during the boot process.
A screen prompt similar to the following displays.
Modem params : 9600,n81d
13. You can change the parameters for the modem port. To change the value, enter the baud
rate (
1200
,
9600
, or
19200
, or
38400
), the parity (
n
for none,
e
for even, or
o
for odd), data
length (
7
or
8
), stop bits (
0
,
1
, or
2
), and port type (
m
for modem,
s
for
SLIP
, or
d
for
down).
For example,
19200n81m
sets the modem port to 19,200 baud, no parity, 8-bit data length,
1 stop bit, and modem mode.
A screen prompt similar to the following displays.
Boot flags : 0xb