Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 574)

Creating a New Group
Page 19-32
Output Framing Type on Physical Ports
Note that for Ethernet, the default output format option is Ethernet II for IP frames and
802.3 for IPX frames.
You can customize your frame translation settings even further through the Switch menu.
The Switch menu allows you to set translations at the frame format level (i.e., incoming
SNAP frames could be translated one way, while incoming LLC frames could be translated
another way) based on protocol type ( IP or IPX ). The Switch menu is explained in Chap-
ter 18, “Configuring LAN Switch Translations.”
6) Ethernet 802.2 Pass Through
For Ethernet ports only. If you answer Yes to this prompt, then frames received in the
IEEE 802.2 format will not be translated according the Output Format Type chosen in line
5; they will be sent as is in their native IEEE 802.2 format. If you answer No , then 802.2
frames will be subject to the Output Format Type chosen in line 5.
OmniS/R
12345678
123456
Group 2
Ports 1 and 2
Server
Receives frames in
Ethernet II format.
Ethernet Port 1:
Format set to
Ethernet II
VLAN 1
(default VLAN #1)
Virtual Router
Workstation
Receives frames in SNAP
format.
Ethernet Port 2:
Format set to
SNAP
The Output Format Type
you set for each port deter-
mines the type of frames
that devices attached to
that port receive.