Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 584)

Modifying a Group or VLAN
Page 19-42
Enabling IP or IPX Routing
If you enable IP or IPX routing by setting the corresponding modvl lines from N to Y , then the
screen automatically refreshes with additional lines for the new router port parameters. All
lines are set to router defaults. The router defaults are as follows:
IP Router
IP Network Address 0.0.0.0
IP Subnet Mask 0.0.0.0
IP Broadcast Address 0.0.0.0
Router Description (no description shown for default)
Routing Disabled No
RIP Mode Silent
Default Framing Type Ethernet II
IPX Router
IPX Network Address 0x0
Router Description (no description shown for default)
Delay in Ticks 0
RIP/SAP Mode RIP and SAP are active
Default Framing Type Ethernet II
You can change any of these defaults as you would any other modvl parameters: enter the
line number, followed by an equal sign (=) and the new parameter.
♦ Note ♦
You must at least enter a Network Address for a new
router or you will not be able to save the configuration.