Displaying static bridge addresses, Displaying static bridge addresses -13 – Alcatel Carrier Internetworking Solutions Omni Switch/Router User Manual
Page 461
Bridging Commands
Page 17-13
Displaying Static Bridge Addresses
You can view static bridge address information by entering the
fs
command. To display the
information, enter the
fs
command as follows:
fs <group number>
where
<group number>
is the number of the group for which you want to view static bridge
MAC addresses. For example, to view MAC addresses for Group 1, you would enter the
following:
fs 1
This command will display a table similar to the following:
Bridge Static Address Summary for Group 1 (Default GROUP (#1))
MAC Address
Slot/Intf/Service/Inst
Static Status
---------------------------
------------------------------
-------------------
002A3113:0012EA
3/
1/
Brg/
1
permanent
As a variation of this command, you can enter the
fs
command at the system prompt with no
group number. This will allow you to view the static bridge addresses on the currently
selected group. For information on selecting a group, see Selecting a Default Group on page
17-7.
The descriptions for the variables in the table displayed with the
fs
command are the same as
those in the table displayed with the
fc