H3C Technologies H3C Intelligent Management Center - Manual (Page 115)

106
{
If the Deploy Status column displays Failed Undeploy, the undeployment failed. To view the
failure cause, hover over Failed Deploy.
Auditing SPB services
VFM audits SPB services periodically to test the connectivity between BEB devices for SPB services in
Normal or Failed Undeploy state.
To audit SPB services without a delay:
1. From the navigation tree, select VAN Fabric Manager > LAN Configuration > SPB.
2. Click the SPB Services tab.
3. Select SPB services in the SPB service list.
4. Click Audit Now.
The Audit Status column displays Auditing.
5. When the audit is complete, click Refresh to verify the audit result:
{
If the Audit Status column displays Normal, the BEBs in the SPB service have full connectivity.
{
If the Audit Status column displays Fault, the SPB service has connectivity problems. To view
detailed audit information, see "
Viewing audit details of SPB services ."
Viewing audit details of SPB services
1. From the navigation tree, select VAN Fabric Manager > LAN Configuration > SPB.
2. Click the SPB Services tab.
3. In the SPB service list, click the Fault link in the Audit Status column.
the Connectivity Audit Information page displays the following information:
{
Connectivity—Connectivity between BEBs. If the state is Unconnected, check the path between
the BEBs for a link or node failure.
{
Local BEB—BEB that sent the probe request.
{
Remote BEB—Destination BEB of the probe request.
{
Last Audit—Time when the audit was performed.
Changing the state of an SPB service from abnormal to normal
For the state of an SPB service to be normal, you must make sure its B-VLAN to ECT algorithm mapping
is the same across the following places:
• SPB service added to the VFM's SPB module.
• B-VLAN plan (see " Creating a B-VLAN plan ").
• SPB devices.
To view B-VLAN to ECT algorithm mappings, see " Viewing SPBM configuration ."
To change the state of an SPB service from abnormal to normal:
1. From the navigation tree, select VAN Fabric Manager > LAN Configuration > SPB.
2. Click the SPB Services tab.
3. In the SPB service list, click the Abnormal link in the Status column.