H3C Technologies H3C Intelligent Management Center - Manual (Page 98)

89
{
Import—Import SPB devices to the SPB module (see " Importing devices ").
{
Synchronize—Synchronize SPB configuration from SPB devices to the SPB module (see
"
Synchronizing SPBM configuration ").
{
Delete—Remove SPB devices from the device list (see " Removing devices ").
{
Set MST Region—Configure the MST region name, revision level, and MSTI 4092 to B-VLAN
mappings. For information about setting the MST region, see "
Configuring MST region
parameters for multiple devices ."
{
Refresh—Refresh the SPB device list for latest device information.
Device List contents
{
Status—Health status of the device. The information is collected by the IMC Platform. For more
information about health states, see H3C IMC Base Platform Administrator Guide.
{
Device Name—Click the device name to view detailed device information. By default, this field
displays the device label and the device IP address. The device label is assigned in the IMC
Platform. The device IP address is the IP address used when the device was added to the IMC
Platform. For more information about device details, see H3C IMC Base Platform Administrator
Guide.
NOTE:
To change the device name format, select System > System Configuration > System Settings,
and then change the setting for Device Info Display.
{
DC—Name of the data center that contains the SPB device. Click the DC name to view devices
that have been imported to the DC. For more information about the DC device list, see
"
Managing network devices ."
{
Device Model—Device model information collected by the IMC Platform. If the device model is
unknown, this column displays Unknown SNMP Product.
{
MST Region—MST region name. All devices in an SPB network must have the same MST
region name for data exchange.
{
VLANs Mapped to MSTI 4092—VLANs mapped to MSTI 4092 on the SPB device. Only data
in these VLANs can be forwarded in an SPB network.
{
MSTP Revision Level—All devices in an SPB network must have the same MSTP revision level
for data exchange.
NOTE:
For more information about MST region and revision level, see MSTP protocol.
{
Last Sync—Time when the most recent synchronization from the SPB device to the SPB module
was performed.
{
Sync Status—Most recent synchronization result: Success, Failure, or Synchronizing.
{
Operation—Click the Operation icon to perform the following tasks:
− View Device Config—Display the SPBM configuration (see " Viewing SPBM configuration ").
− Set MST Region—Change the MST region (see " Configuring MST region parameters for
one device ").
− Interface List—Display the interface list (see " Managing interfaces ").