Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 102
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
102
5. Select the picture quality as
High
,
Medium
, or
Low
. The higher the picture quality is, the larger size the
picture will be.
6. Click
Save
.
Set Parameters for Temperature Screening Terminal
For temperature screening terminal, you can set its parameters.
NOTE:
This function should be supported by the device.
1. Enter the
Access Control
module.
2. On the navigation bar on the left, enter
Advanced Function
→
More Parameters
.
3. Select an access control device in the device list and click
Temperature Screening Terminal
.
4. Set the parameters.
NOTE:
These parameters displayed vary according to different device models.
•
Algorithm
– Select
Deep Learning
as the identity picture database.
•
Save Authenticating Face Picture
– If enabled, the captured identity picture when authenticating will
be saved on the device.
•
ECO Mode
– After enabling the ECO mode, the device can authenticate identities in the low light or
dark environment. And you can set he ECO mode threshold, ECO mode (1:N), and ECO mode (1:1).
NOTE:
Only device in the normal mode supports configuring ECO mode parameters.
•
Work Mode
– Set the device work mode as Access Control Mode. The access control mode is the
device normal mode. You should authenticate your credential for accessing.
5. Click
Save
.
Enable M1 Card Encryption
M1 card encryption can improve the security level of authentication.
NOTE:
The function should be supported by the access control device and the card reader.
1. Enter the Access Control module.
2. On the navigation bar on the left, enter
Advanced Function
→
More Parameters
.
3. Select an access control device in the device list and click
M1 Card Encryption
to enter the M1 Card
Encryption page.
4. Set the switch to on to enable the M1 card encryption function.
5. Set the sector ID.
NOTE:
The sector ID ranges from 1 to 100.