Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal - Manual (Page 57)

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA 57
Result
When you authenticate on the initial page, the authentication will be marked as the configured attendance
status according to the configured schedule.
Example: If the Break Out Schedule is set as Monday 11:00, and the Break In Schedule is set as
Monday 12:00, the valid user’s authentication from Monday 11:00 to 12:00 will be marked
as a break.
6.10.3 Set Manual Attendance via Device
Set the attendance mode as manual, and you can select a status manually when you take attendance.
Before You Start
Add at least one user, and set the user’s authentication mode. For details, see User Management .
1. Tap T&A Status to enter the T&A Status page.
2. Set the Attendance Mode as Manual .
Figure 45, Manual Attendance Mode
3. Enable the Attendance Status function.
Result
You should select the attendance status manually after authentication.
NOTE: If you do not select a status, the authentication will be failed and it will not be marked as a
valid attendance.
6.10.4 Set Manual and Auto Attendance via Device
Set the attendance mode as Manual and Auto , and the system will automatically change the attendance
status according to the configured parameters. At the same time you can manually change the attendance
status after the authentication.
Before You Start
Add at least one user, and set the user’s authentication mode. For details, see User Management .
1. Tap T&A Status to enter the T&A Status page.