2 set identity picture parameters – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 48
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
48
Figure 36, Basic Parameters
Table 6-2 Basic Parameters
Parameter
Description
Community No.
Set the device installed community No.
Building No.
Set the device installed building No.
Unit No.
Set the device installed Unit No.
Voice Prompt
Tap
or
to disable or enable the voice prompt.
Voice Volume
Adjust the voice volume. The larger the value, the louder the volume.
Application Mode
You can select either others or indoor according to actual environment.
Language
Select the system language.
NOTE:
The device will reboot after the language is changed.
6.7.2 Set Identity Picture Parameters
You can set the identity 1:N security level, 1:1 security level, recognition interval, liveness security level, WDR
level, pupillary distance, face with mask detection, and ECO mode.
On the Home page, tap
System
(System Settings) to enter the System Settings page.