Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 6
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
6
case of some lithium battery types).
•
Do not dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery, which may
result in an explosion.
•
Do not leave the battery in an extremely high temperature surrounding environment, which may result in
an explosion or the leakage of flammable liquid or gas.
•
Do not subject the battery to extremely low air pressure, which may result in an explosion or the leakage
of flammable liquid or gas.
•
Dispose of used batteries according to the instructions.
•
+
identifies the positive terminal(s) of equipment which is used with, or generates direct current.
-
identifies the negative terminal(s) of equipment which is used with, or generates direct current.
•
CAUTION: This bracket is intended for use only with DS-K1T341BMI-T/DS-K1T341BMWI-T temperature
screening terminal. Use with other equipment may result in instability causing injury.
•
CAUTION: This equipment is for use only with the corresponded bracket. Use with other (carts, stands, or
carriers) may result in instability causing injury.
•
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Cautions!
•
Provide a surge suppressor at the inlet opening of the equipment under special conditions such as the
mountain top, iron tower, and forest.
•
No naked flame sources, such as lighted candles, should be placed on the equipment.
•
The serial port of the equipment is used for debugging only.
•
Burned fingers when handling the back panel. Wait one-half hour after switching off before handling the
parts.
•
Do not drop the device or subject it to physical shock, and do not expose it to high electromagnetism
radiation. Avoid the equipment installation on vibrations surface or places subject to shock (ignorance can
cause equipment damage).
•
Install the equipment according to the instructions in this manual. To prevent injury, this equipment must
be securely attached to the floor/wall in accordance with the installation instructions.
•
Do not place the device in extremely hot (refer to the specification of the device for the detailed operating
temperature), cold, dusty or damp locations, and do not expose it to high electromagnetic radiation.
•
The device cover for indoor use shall be kept from rain and moisture.
•
Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is
forbidden (ignorance can cause fire danger).
•
Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which