2 configure device actions for access event, 3 configure device actions for card swiping – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual

Page 105

Advertising
background image

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual

UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA

105

NOTE:

For details about setting e-mail parameters, refer to

Set Email Parameters

in the user

manual of client software.

2) Click

OK

.

5. Enable the event so that when the event is detected, en event will be sent to the client and the linkage

actions will be triggered.

6. (Optional): Click

Copy to...

to copy the event settings to other access control device, alarm input, door, or

card reader.

7.8.2 Configure Device Actions for Access Event

You can set the access control device’s linkage actions for the access control device’s triggered event. When

the event is triggered, it can trigger the alarm output, host buzzer, and other actions on the same device.

NOTE:

It should be supported by the device.

1. Click

Access Control → Linkage Configuration

.

2. Select the access control device from the list on the left.

3. Click

Add

button to add a new linkage.

4. Select the event source as

Event Linkage

.

5. Select the event type and detailed event to set the linkage.

6. In the

Linkage Target

area, set the property target to enable this action.

Buzzer on Controller

– The audible warning of access control device will be triggered.

Capture

– The real-time capture will be triggered.

Access Point

– The door status of open, close, remain open, and remain close will be triggered.

NOTE:

The target door and the source door cannot be the same one.

7. Click

Save

.

8. (Optional): After adding the device linkage, you can do one or more of the following:

Edit Linkage Settings

– Select the configured linkage settings in the device list and you can edit its

event source parameters, including event source and linkage target.

Delete Linkage Settings

– Select the configured linkage settings in the device list and click

Delete

to

delete it.

7.8.3 Configure Device Actions for Card Swiping

You can set the access control device’s linkage actions for the specified card swiping. When you swipe the

specified card, it can trigger the host buzzer, and other actions on the same device.

Advertising