6 configure rs-485 parameters – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 131
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
131
Restore Settings
1.
On the
Device for Management
page, click
Remote Configuration
→
System
→
System Maintenance
to
enter the
System Maintenance
tab.
•
Restore Default
– The parameters will be restored the default ones, excluding the IP address.
•
Restore Part of Settings
– Restore all settings except communication settings and the remote user
settings to default ones.
•
Restore All
– All device parameters will be restored to the default ones. The device should be activated
after restoring.
Import and Export
1. On the
Device for Management
page, click
Remote Configuration
→
System
→
System Maintenance
to
enter the
System Maintenance
tab.
2. Import or export configuration file.
•
Import Configuration File
– Import the configuration file from the local PC to the device.
NOTE:
The configuration file contains the device parameters.
•
Export Configuration File
– Export the configuration file from the device to the local PC.
NOTE:
The configuration file contains the device parameters.
Upgrade
1.
On the
Device for Management
page, click
Remote Configuration
→
System
→
System Maintenance
to
enter the
System Maintenance
tab.
2.
Select a device type from the drop-down list, click
Browse
and select an upgrade file from the local
computer, and click
Upgrade
.
NOTE:
If you select
Card Reader
as the device type, you should also select a
Card Reader No.
from
the drop-down list.
The upgrade will lasts for about 2 min. Do not power off during the upgrading. After
upgrading, the device will reboot automatically.
7.12.6 Configure RS-485 Parameters
You can set the RS-485 parameters, including the baud rate, data bit, stop bit, parity type, communication
mode, work mode, and connection mode.
1. Click
Maintenance and Management
→
Device
to enter the device list.
2. Click to enter the remote configuration page.
3. Click
System
→
RS-485 Settings
to enter the
Configuring the RS-485 Parameters
tab.