Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal - Manual (Page 129)

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA 129
• Generate Report – Select one added report and click Report to generate the report instantly and you
can view the report details.
7.12 Remote Configuration (Web)
Configure device parameters remotely.
7.12.1 View Device Information
View and set device name, view device type, serial No., version, lock number, and local RS-485 number.
1. Select a device from the Device for Management tab and click → System → Device Information to
enter the Device Information page.
2. You can set the device name, view the device type, serial No., version, lock number, and local RS-485
number.
3. Click Save to save the settings.
7.12.2 View Open Source Software License
1. Select a device from the Device for Management tab.
2. Click → System → Device Information → About .
3. Click View Licenses to view the open source code license.
7.12.3 Change Device Password
You can change the device password.
Before You Start
Make sure the device is activated. For details, see Activation .
1. On the Device for Management page, click → System → User to enter the User tab.
2. Select a user and click Edit to enter the Edit page.
3. Input the old password, create a new password, and confirm the new password.
STRONG PASSWORD RECOMMENDED − The password strength of the device can be
automatically checked. We highly recommend that you create a strong password of your own
choosing (using a minimum of eight characters, including at least three of the following
categories: upper case letters, lower case letters, numbers, and special characters) in order to
increase the security of your product. We also recommend that you reset your password
regularly. Especially in high security systems, resetting the password monthly or weekly can
better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end user.