Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal - Manual (Page 46)

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA 46
The available parameters’ descriptions are as follows:
Table 6-1 Temperature Measurement Parameters Descriptions
Parameter Description
Enable Temperature
Detection
When enabling the function, the device will authenticate the permissions
and at the same time take the temperature. When disabling the device, the
device will authenticate the permissions only.
Over-Temperature
Threshold(Max./Min.)
Edit the threshold according to actual situation. If the detected
temperature is higher or lower than the configured parameters, an alarm
will be triggered. By default, the value is 99.14° F (37.3° C).
Temperature Compensation
If the measured temperature is higher/lower than the actual object’s
temperature, you can set the compensation temperature here. Available
range: -146.2° to 210.2° F (-99° to 99° C)
Door Not Open If Temp. is
Abnormal
When enabling the function, the door will not open when the detected
temperature is higher or lower than the configured temperature threshold.
By default, the function is enabled.
Temperature Measurement
Only
When enabling the function, the device will not authenticate the
permissions, but only take the temperature. When disabling the function,
the device will authenticate the permissions and at the same time take the
temperature.
Unit Select a temperature unit according to your preference.
Measurement Area
Calibration/Measure Area
Settings
Configure the temperature measurement area and the correction
parameters.
6.6 Identity Authentication
After network configuration, system parameters configuration and user configuration, you can go back to the
initial page for identity authentication. The system will authenticate person according to the configured
authentication mode.
You can authenticate identity via 1:1 matching or 1:N matching.
• 1: N Matching – Compare the captured identity picture with all identity pictures stored in the device.
• 1: 1 Matching – Compare the captured identity picture with the identity pictures linked person
information in the device.
6.6.1 Authenticate via Multiple Credential
Before You Start
Set the user authentication type before authentication. For details, see Set Authentication Mode .
1. If the authentication mode is Card and Face, Password and Face, Card and Password, authenticate any
credential according to the instructions on the live view page.
NOTE: The card can be normal IC card, or encrypted card.
2. After the previous credential is authenticated, continue authenticate the other credential.