9 maintenance, 1 reboot device, 2 data management – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual

Page 52

Advertising
background image

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual

UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA

52

The available parameters descriptions are as follows:

Table 6-4 Access Control Parameters Descriptions

Parameter

Description

Terminal Auth. Mode

(Terminal Authentication

Mode)

Select the temperature screening terminal’s authentication mode. You

can also customize the authentication mode.

NOTE:

Biometric recognition products are not 100%

applicable to anti-spoofing environments. If you

require a higher security level, use multiple

authentication modes.

If you adopt multiple authentication modes, you

should authenticate other methods before

authenticating identity.

Reader Auth. Mode (Card

Reader Authentication Mode) Select the card reader’s authentication mode.
Door Contact

You can select “Open (Remain Open)” or “Close (Remian Closed)”

according to your actual needs. By default, it is Close (Remian Closed).

Door Locked Time

Set the door unlocking duration. If the door is not opened for the set

time, the door will be locked. Available door locked time range: 1 to 255s.

6.9 Maintenance

6.9.1 Reboot Device

Tap

Maint.

(Maintenance) on the System Settings page and tap

Reboot

. Confirm the operation and the device

starts rebooting.

Figure 40, Reboot Device Page

6.9.2 Data Management

On the Data Management page, you can delete user data, restore to factory settings, or restore to default

settings.

Advertising