Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 87
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
87
persons to access.
7. Click
Save
. You can view the selected person(s) and the selected access point(s) on the right side of the
interface.
Figure 50, Display the Selected Person(s) and Access Point(s)
8. After adding the access groups, you need to apply them to the access control device to take effect.
1) Select the access group(s) to apply to the access control device.
2) Click
Apply All to Devices
start applying all the selected access group(s) to the access control device or
door station.
3) Click
Apply All to Devices
or
Apply Changes to Devices
.
•
Apply All to Devices –
This operation will clear all the existed access groups of the selected devices
and then apply the new access group to the device.
•
Apply Changes to Devices –
This operation will not clear the existed access groups of the selected
devices and only apply the changed part of the selected access group(s) to the device(s).
4) View the applying status in the Status column or click
Applying Status
to view all the applied access
group(s).
NOTE:
You can check
Display Failure Only
to filter the applying results.
The selected persons in the applied access groups will have the authorization to enter/exit the selected
doors/door stations with their linked card(s).
9. (Optional): Click to edit the access group if necessary.
NOTE:
If you change the persons’ access information or other related information, you will view
the prompt
Access Group to Be Applied
on the right corner of the client.