Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal - Manual (Page 22)

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA 22
4. Remove the bottom cover and the back cover by removing the screws (M3).
Figure 12, Remove Bottom Cover and Back Cover
5. Route the cable through the cable hole of the bottom of the bracket, and connect to corresponding
external devices’ cables.
6. Align the device with the drilled holes on the ground and insert four supplied expansion bolts (M8). Make
sure the expansion bolts are higher than the ground.
7. Secure the expansion bolts with nuts.
Figure 13, Secure Bracket on Surface