3 set rs-485 parameters – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual

Page 38

Advertising
background image

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual

UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA

38

Figure 31, Wi-Fi Settings

3. Enable the Wi-Fi function.

4. Select a Wi-Fi in the list to enter the Wi-Fi parameters settings page.

5. Select an IP mode.

If selecting

DHCP

, you should input the Wi-Fi password.If selecting

Static

, you should input the Wi-Fi

password, IP address, subnet mask and gateway.

NOTE:

Numbers, upper case letters, lower case letters, and special characters are allowed in the

Wi-Fi password.

6. Tap

OK

to save the settings and go back to the Wi-Fi tab.

7. Tap

to save the network parameters.

6.3.3 Set RS-485 Parameters

The temperature screening terminal can connect external access controller, secure door control unit or card

reader via the RS-485 terminal.

Advertising