Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal - Manual (Page 24)

DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA 24
Chapter 4 Wiring
The device supports connecting to the RS-485 terminal, the door lock, the exit button, the alarm output/input
devices, the Wiegand card reader, the access controller, and the power supply. You can wire the peripherals
according to the descriptions below.
If connect the Wiegand card reader with the access controller, the temperature screening terminal can
transmit the authentication information to the access controller and the access controller can judge whether
to open the door or not.
NOTE: If the cable size is 18 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 20 m.
If the cable size is 15 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 30 m.
If the cable size is 12 AWG, you should use a 12 V switched-mode power supply. And the
distance between the power supply and the device should be no more than 40 m.
4.1 Terminal Description
The terminals contains power input, RS-485, Wiegand output, and door lock.
The descriptions of the terminals are as follows:
Table 4-1 Terminal Descriptions
Group No. Function Color Name Description
Group A
A1
Power Input
Red +12 V 12 VDC Power Supply
A2 Black GND Ground
Group B
B1
RS-485
Yellow 485+
RS-485 Wiring
B2 Blue 485-
B3 Red/Black GND Ground
Group C
C1
Wiegand
Green W0 Wiegand Wiring 0
C2 White W1 Wiegand Wiring 1
C3 White/Black GND Ground
Group D
D1
Door Lock
White/Purple NC Lock Wiring (NC)
D2 White/Yellow COM Common
D3 White/Red NO Lock Wiring (NO)
D4 Yellow/Green SENSOR Door Contact
D5 Black GND Ground
D6 Yellow/Gray BUTTON Exit Door Wiring
D7 Yellow/Black GND Ground
4.2 Wire Normal Device
You can connect the terminal with normal peripherals.