Configure parameters for door – Hikvision DS-K1T341BMWI-T Touchless Identity Authentication Terminal User Manual
Page 89
DS-K11T341BM(W)I-T Touchless Identity Authentication Terminal User Manual
UM DS-K1T341BM(W)I-T Touchless Identity Authentication Terminal 031221NA
89
•
Voice Prompt –
If you enable this function, the voice prompt is enabled in the device. You can hear the
voice prompt when operating in the device.
•
Upload Pic. After Linked Capture –
Upload the pictures captured by linked camera to the system
automatically.
•
Save Pic. After Linked Capture –
If you enable this function, you can save the picture captured by
linked camera to the device.
•
Identity Recognition Mode
Normal Mode –
Authenticate identity via the camera normally.
Deep Mode –
The device can recognize a much wider people range than the normal mode. This mode
is applicable to a more complicated environment.
•
Enable NFC Card –
If enable the function, the device can recognize the NFC card. You can present NFC
card on the device.
•
Enable M1 Card –
If enable the function, the device can recognize the M1 card. You can present M1
card on the device.
•
Enable EM Card –
If enable the function, the device can recognize the EM card. You can present EM
card on the device.
•
Enable CPU Card –
Reserved. If enable the function, the device can recognize the CPU card. You can
present CPU card on the device.
•
Enable ID Card –
Reserved. If enable the function, the device can recognize the ID card. You can
present ID card on the device.
4. Click
OK
.
5. (Optional): Click
Copy to
, and then select the access control device(s) to copy the parameters in the page
to the selected device(s).
Configure Parameters for Door
After adding the access control device, you can configure its access point parameters.
1.
Click Access Control → Advanced Function → Device Parameter.
2. Select an access control device on the left panel, and then click to show the doors of the selected
device.
3. Select a door to show its parameters on the right page.
4. Edit the door parameters.
NOTE:
The displayed parameters may vary for different access control devices.
•
Name –
Edit the card reader name as desired.