FUJITSU SPARC M4000 - Manual (Page 106)

2-50 SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
Note – To enable the SSH, to generate the host key, and to disable the telnet, the
XSCF reset is required. Please reset the XSCF using by rebootxscf (8) command.
After the XSCF reset, the XSCF session is disconnected. Please log in again to the
XSCF. The SSH or telnet settings are automatically applied to the standby XSCF Unit
for a system with a redundant XSCF configuration.
Note – In this system, the RW or RO consoles from multiple domains can be used.
Only one RW console can be used for each domain. Use the console (8) command
to specify either the RW console or RO console as a domain console. For details
about consoles, see
Chapter 3 .
Enabling or Disabling SSH/Telnet
■
Command operation
1. Use the showssh (8) command to display SSH settings or use the showtelnet
(8) command to display telnet settings.
Display
timeout Display the timeout period for automatic
logout. showautologout
timeout After logging in XSCF, if the system is not
used for a certain period, logout is
automatically performed. Specify the timeout
period (minutes). Note that no time
monitoring is performed while the domain
console is the current console. setautologout The default timeout period
is 10 minutes. A value
ranging from 1 to 255 can
be specified for the timeout
period.
Install/
Uninstall
user public
key Install and uninstall the SSH user public key.
One user can install multiple user public
keys. setssh When you install/
uninstall the user public
key, the useradm privilege
is required. (Note)
TABLE 2-9 SSH/Telnet Administration (Continued)
Item Description Shell command Remarks