FUJITSU SPARC M4000 - Manual (Page 193)

Chapter 3 Connecting to the XSCF and the Server 3-3
(8) command. After that, you can use the domain console (OS console) (see Note
below). You can return to the XSCF Shell console by pressing the "#." (sharp and
period) keys (default value) while holding down the Enter key. The XSCF functions
do not vary according to the port type.
Note that the XSCF Web cannot be used on PCs and workstations that are connected
via serial port.
Note – The function used to switch from the XSCF Shell to the domain console by a
command is called the XSCF console redirection function.
Note – In the server, each system board is serially and directly connected to the
XSCF Unit (multipath configuration). When the user performs the console (8)
command, XSCF automatically selects a path to the valid domain.
Serial
The XSCF Shell and domain console (OS console) can be used while a terminal is
connected to a serial port.
Ethernet
The XSCF Shell and domain console (OS console) can be used with SSH or telnet at
a terminal using an Ethernet (referred to as XSCF-LAN, in this document)
connection. Also, the XSCF Web can be used, with the appropriate browser settings.
Other functions which rely on XSCF-LAN (Ethernet) connectivity are the mail
notification function, the SNMP function, the log archiving function, the remote
maintenance service function, time synchronization with an external NTP server,
and user authentication with an LDAP server.
TABLE 3-1 lists the types of terminals connected to each port shown in FIGURE 3-1 and
corresponding port numbers.