FUJITSU SPARC M4000 - Manual (Page 107)

<Example 1> Display SSH settings
XSCF> showssh
SSH status: enabled
RSA key:
:
DSA key:
:
<Example 2> Display telnet settings
XSCF> showtelnet
Telnet status: disabled
Chapter 2 Setting Up XSCF 2-51
2. Use the setssh (8) command to make the SSH settings or use the settelnet
(8) command to make the telnet settings.
<Example 1> Enable SSH.
XSCF> setssh -c enable
Continue? [y|n] :y
Please reset the XSCF by rebootxscf to apply the ssh settings.
<Example 2> Disable telnet.
XSCF> settelnet -c disable
Please reset the XSCF by rebootxscf to apply the telnet settings.
3. To enable the SSH and to disable the telnet, the XSCF reset is required. Use the
rebootxscf (8) command to reset the XSCF.
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n] :y
■ After the XSCF reset, the XSCF session is disconnected. Please log in again to the
XSCF.