FUJITSU SPARC M4000 - Manual (Page 84)

2-28 SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
Applying the XSCF Network Settings
■ Command operation
1. After performing the setnetwork (8), sethostname (8), setroute (8), and
setnameserver (8) commands, apply these Network settings.
2. Perform the applynetwork (8) command on the XSCF Shell. When
performing the command, the network settings are displayed and you can
confirm whether the settings should be applied.
XSCF> applynetwork
The following network settings will be applied:
xscf#0 hostname :scf0-hostname
DNS domain name :company.com
nameserver :10.0.0.2
interface :xscf#0-lan#0
status :up
IP address :192.168.1.10
netmask :255.255.255.0
route :-n 192.168.1.0 -m 255.255.255.0 -g 192.168.1.1
interface :xscf#0-lan#1
status :down
IP address :
netmask :
route :
Continue? [y|n] :y
Note – When the XSCF Unit is in redundant configuration, ISN addresses must be
in the same network subnet.
3. Use the rebootxscf (8) command to reset the XSCF and to complete the settings.
XSCF> rebootxscf
The XSCF will be reset. Continue? [y|n] :y
■ At this time, the window session is disconnected, so please reconnect to the XSCF
by using the new network interface and log in again.
4. Display the Network Configuration by using the shownetwork(8),
showhostname (8), showroute(8) and shownameserver(8) commands again
and check the new network information.