FUJITSU SPARC M4000 - Manual (Page 249)

Chapter 5 Overview of the XSCF Shell 5-13
showstatus
The system administrator can use the showstatus (8) command to list degraded
components.
5.5 Domain Control and Maintenance
Commands
This section describes the typical XSCF Shell commands that manage resource
assignment to domains and resource removal from domains, install devices, remove
devices, replace devices, and enable or disable functions.
■ showdevices / cfgdevice
■ console
■ showdcl / setdcl
■ showfru / setupfru
■ addfru / deletefru / replacefru
■ showboards / addboard / deleteboard / moveboard
■ showdomainmode / setdomainmode
showdevices / cfgdevice
The cfgdevice (8) command displays the domain to which a DVD drive unit or
tape drive unit is assigned. The showdevices (8) command displays the operating
status of resources installed on a system board (XSB). The system administrator can
use this command to determine the devices to be assigned to a domain and check
whether the DR function can be used to connect or disconnect an XSB.
console
The console (8) command establishes a connection to the domain console. This
command supports both interactive and read-only connections.