FUJITSU SPARC M4000 - Manual (Page 284)

8-14 SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
Note – The display might be different according to XCP version and system
configuration.
At this time, the XSCF will reset and the XSCF session will disconnect, so
please connect the XSCF again. Only the application of the XSCF firmware is
completed.
Note – The work described below applies to a system with redundant XSCF Units.
i) Perform the firmware update in order, beginning with the standby side and then
the active side automatically. After the update on the standby side is completed, the
active and standby sides are switched. At this time, the XSCF reset is done and the
XSCF session is disconnected.
ii) Re-connect the XSCF and log in again.
iii) XSCF firmware update is completed.
d. To confirm that the XSCF firmware update has finished, use the showlogs
(8) command with the monitor option.
XSCF> showlogs monitor
:
Feb 20 07:25:48 FF1-1-0 monitor_msg: SCF:XCP update has been completed (XCP
version=1020)
4. To complete the update of the OpenBoot PROM firmware, restart the domain.
5. Confirm that the version of the system firmware that is running is that of the
firmware applied at the XSCF Shell command line by using the version (8)
command.
■ Web browser operation
For information about using the XSCF Web, see Chapter 9 .
1. Start the XSCF Web.
https://manual.host / (Specify the host name or IP address of XSCF)
2. The login window of the XSCF Web console is displayed. Please enter an XSCF
user account and password.
3. Select [Utility]-[Firmware Update] to display the menu.