FUJITSU SPARC M4000 - Manual (Page 133)

<Example> Display of the status when no management information has
been set
XSCF> showsnmp
Agent Status: Disabled
Agent port: 161
System Location: Unknown
System Contact: Unknown
System Description: Unknown
:
Chapter 2 Setting Up XSCF 2-77
2. Use the setsnmp (8) command to make the SNMP settings.
<Example> Specifying the installation location of the system, system
description, and mail address of the administrator
XSCF> setsnmp -l MainTower21F -c [email protected] -d DataBaseServer
3. Use the setsnmp (8) command to enable the SNMP agent.
<Example 1> Enabling the agent.
XSCF> setsnmp enable
<Example 2> Disabling the agent.
XSCF> setsnmp disable
4. Confirm the SNMP settings.
XSCF> showsnmp
Agent Status: Enabled
Agent port: 161
System Location: MainTower21F
System Contact: [email protected]
System Description: DataBaseServer
: