FUJITSU SPARC M4000 - Manual (Page 268)

7-8 SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
7.4 Setting Up the XSCF SNMP Agent
Function
This section explains how to set up the XSCF SNMP agent function.
The workflow is as described below. Perform each setup step with the setsnmp (8)
command of the XSCF Shell. For details on setup, see
Chapter 2 .
Starting Transmission
■ Step 1:
For setting items common to the agent protocols of SNMPv1, SNMPv2c, and
SNMPv3, specify the management information listed below.
The following setting items are reflected in the MIB information:
■
Installation location of the agent system
■
Mail address of the administrator
■
Description of the agent system
■
Port number of the agent (listening port number)
■ Step 2:
Specify the following management information for SNMPv3, SNMPv1, and
SNMPv2c:
[SNMPv3 management information settings]
■
User name (Note)
■
Authentication password (Note)
■
Encryption password (Note)
■ Authentication algorithm
■
Port number of the trap destination
■
Host name of the trap destination
Note – A user name, authentication password, and encryption password that are
common to both the sending and receiving sides must be set for SNMPv3.
[SNMPv1 and SNMPv2c management information settings]
■
Defined TRAP type (specify v1, v2c, or inform <v2c in your response>)