FUJITSU SPARC M4000 User Manual
Page 61
Chapter 2 Setting Up XSCF
2-5
4. Set the time.
• Set and display the time zone.
• Set and display the XSCF time.
showtimezone
(8)
settimezone
(8)
showdate
(8), setdate(8)
• Reset the time subtraction between the XSCF
and the domain.
resetdateoffset
(8)
(See
Section 2.2.4, “Time Administration”
)
■
When the system time is updated, the XSCF reset is done and the XSCF session is
disconnected. Please log in again to the XSCF using the new user account.
Note –
NTP settings (setntp(8)) are done after the Network settings or the Domain
Configuration.
5. Configure the SSH/telnet settings.
• Select SSH or telnet.
• Display and specify the timeout monitoring
period.
setssh
(8), settelnet(8),
showautologout
(8),
setautologout
(8),
(See
Note –
XSCF reset is required to enable SSH and to disable telnet. Go to the next
step when you reset it later.
If you want to reset XSCF immediately, use the rebootxscf (8) command. After the
XSCF reset, the XSCF session is disconnected. Log in again to the XSCF.
Note –
You can enable SSH and telnet at the same time. However, the telnet
connection is not a secure connection protocol. We recommend that when you enable
SSH that you disable telnet.
6. Confirm the XSCF host public key.
■
Before using SSH for XSCF-LAN connection, record the fingerprint. Or, copy the
text data of the host public key and save the data to a specific directory of the
client. (The following screen is an example.)