FUJITSU SPARC M4000 - Manual (Page 183)

Chapter 2 Setting Up XSCF 2-127
2.2.15 Altitude Administration
This section explains the altitude settings. The server changes the system monitoring
due to the altitude of the server. Therefore, the operator must set the altitude during
the initial system setting. This setting is done by FEs.
TABLE 2-30 lists setting items and the corresponding shell commands.
TABLE 2-30 Altitude Administration
Item Description Shell Command Remarks
Display settings Display the altitude settings for the server. showaltitude
Altitude Specify the location altitude of the server:
A set unit is specified in increments of 100 meters.
The setting of less than 100 meters is rounded up. setaltitude A negative altitude
cannot be set.
Setting Altitude
■
Command operation
1. Use the showaltitude (8) command to check the current altitude settings.
XSCF> showaltitude
1000m
2. Use the setaltitude (8) command to set the altitude settings.
<Example 1> Specify an altitude of 1000 meters
XSCF> setaltitude -s altitude=1000
1000m
<Example 2> Specify an altitude of 200 meters
XSCF> setaltitude -s altitude=200
200m
Note – To apply the specified configuration, execute the rebootxscf (8) command
and reset XSCF.