FUJITSU SPARC M4000 User Manual
Page 168
2-112
SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
6. Use the showboards (8) command to discplay the XSB status again.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00) Assigned n n n Passed Normal n
01-0 01(00) Assigned n n n Passed Normal n
01-1 SP Available n n n Passed Normal n
01-2 02(09) Assigned n n n Passed Normal n
01-3 02(10) Assigned n n n Passed Normal n
7. Use the poweron (8) command to start up the domain ID.
XSCF> poweron –a
DomainIDs to power on:01,02
Continue? [y|n] :y
01 :Powering on
02 :Powering on
*Note*
This command only issues the instruction to power-on.
The result of the instruction can be checked by the
"showlogs power".
8. Use the showboards (8) command to confirm that the XSB has been added to
domain ID 1.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00) Assigned y y y Passed Normal n
01-0 01(00) Assigned y y y Passed Normal n
01-1 SP Available y n n Passed Normal n
01-2 02(09) Assigned y y y Passed Normal n
01-3 02(10) Assigned y y y Passed Normal n
Note –
When moving the system board to the domain by using the DR function that
operates the XSB without stopping the domain, see the Dynamic Reconfiguration
User’s Guide.