FUJITSU SPARC M4000 User Manual
Page 63
Chapter 2 Setting Up XSCF
2-7
8. Configure the network.
• Display and
set the DSCP
.
• Display XSCF network settings (enable/disable, IP
address, netmask) and configure an XSCF network.
showdscp
(8), setdscp(8),
shownetwork
(8),
setnetwork
(8)
• Display and set XSCF host name.
showhostname
(8),
sethostname
(8)
• Display XSCF route settings (destination IP address,
gateway, netmask, interface) and configure an XSCF
route.
showroute
(8), setroute(8)
• Display and make the DNS settings (enable/disable,
IP address, add/delete).
shownameserver
(8) ,
setnameserver
(8)
• Apply network settings.
applynetwork
(8)
(See
)
■
Perform the applynetwork (8) command to apply the network settings. To
complete the network settings, the XSCF reset is required. Go to the next step
when you reset it later. When you want to reset it now, perform the rebootxscf
(8) command to apply the settings. Then, the XSCF reset is done and the XSCF
session is disconnected. Please connect the XSCF and log in to the XSCF again.
■
Here, when you set up the XSCF by the XSCF-LAN connection, please change the
cable from the serial port to the XSCF-LAN port. (Change the serial cable to the
LAN cable.) When you use the controller that converts the RS-232C interface and
LAN interface, you do not need to change the cable. Reconnect to the XSCF using
the new user account and the new IP address and login to the XSCF again.
For details on connecting the SSH, telnet, and serial port, and login to the XSCF,
see
. Moreover, the telnet connection is not a secure connection
protocol. We recommend that you use SSH.
During login using SSH on XSCF Shell (Ethernet connection), you are prompted
to confirm the authenticity of the fingerprint of the host public key. The reply is
"yes" if the fingerprint is the same as the memo in
. If the reply is not the
same, please confirm that the IP address is correct and not duplicated. There is a
possibility that IP address spoofing has occurred.
RSA key fingerprint is
xxxxxx
Connecting? [yes|no] : yes
Type the passphrase you have already set in the case that you would be using
SSH with user key authentication.