FUJITSU SPARC M4000 - Manual (Page 137)

Chapter 2 Setting Up XSCF 2-81
Disabling Traps to the Target Host of SNMPv1/SNMPv2c
■
Command operation
1. Use the showsnmp (8) command to display SNMP settings.
XSCF> showsnmp
2. Use the setsnmp (8) command to disable the trap destination host of the
SNMPv1 or SNMPv2c target.
<Example> Disables trap host for SNMPv2c type.
XSCF> setsnmp remtraphost -t v2 host2
3. Use the showsnmp (8) command to confirm the disabling of the target the trap
destination host.
XSCF> showsnmp
Specifying a User Authentication Algorithm, Creating or Changing an
Authentication/Encryption Password, Copy a User, or Delete a User, All
of Which is USM Management Information
■ Command operation
1. Use the showsnmpusm (8) command to display USM management information.
XSCF> showsnmpusm
Username Auth Protocol
-------------- ------------------
yyyyy MD5
user2 MD5