Quantum Data 881 - Manual (Page 100)

82 Chapter 2 Testing Video Displays
Keypad Utility
This section describes the Keypad utility and how to use it.
The keypad provides you with a quick and convenient way of changing between formats
and images. The interface from the Keypad to the generator is through the serial interface.
Once connected you can change between formats and image with a single key stroke. You
can also control test sequences using the Keypad.
Use the following procedures to install and operate the remote keypad.
To install and enable the keypad:
1. Shut off the generator.
2. Connect the keypad to the serial port on the generator.
The serial port is on the back of the generator on the lower panel. It is labeled Serial.
3. Press the Tools key. The Tools menu appears on the generator’s display as shown
below.
4. Choose System pressing the adjacent item selection key. The following display
appears on the generator’s display.
5. Choose Serial to access the menu for enabling the Keypad. The following display
appears on the generator’s display.
6. Press the Options key. The following information appears on the generator’s display:
7. Press the softkey adjacent to the Keypad item to enable the keypad function.
A + appears next to the Keypad item indicating that the functionality is enabled.
System
Sequence
Probe
AFC
Analyzer
Reports
ImgShift
CEC
Clock Clone*
CalFactor Server
Network About
Serial GPib
Serial Port
9600 baud
8 N 1
-Keypad