Quantum Data 881 - Manual (Page 320)

302 Chapter 10 Testing HDMI Sink Devices
Setting up the generator for HDMI testing
This section provides general procedures for setting up the generator for HDMI testing.
The procedures below can be performed using the front panel or the command line
interface.
To set up the generator for HDMI testing:
1. Connect an HDMI-to-HDMI cable between the HDMI display device under test and the
either one of the HDMI OUT connectors on the generator.
2. Activate the HDMI-H interface on the output port:
a. Press the Interface key to access the list of interfaces. A listing of signal interfaces
appears on the generator’s display as shown below.
b. Choose the HDMI-H item by pressing the adjacent soft key.
The interface is activated and the port outputs the currently selected image and format.
Alternatively, to select the interface through the command line, enter the following
commands:
XVSI 4 // Selects the HDMI-H interface
ALLU // Applies the interface setting to the generator
3. (Optional) Disable the second HDMI output:
a. Press the Options key. The following information appears on the generator’s
display.
b. Disable the second output by pressing the soft key adjacent to the Disable 2 option.
A + appears next to Disable 2 option, indicating it is enabled.
VGA
HDMI-D CVBS
S-VIDEO
SDI
*
HDMI-H
VGA
HDMI-D CVBS
S-VIDEO
SDI *HDMI-H
+Output Mark #1-
Disable 2-