Quantum Data 881 - Manual (Page 409)

881/882 Video Test Generator User Guide (Rev A.22) 391
To test acknowledgement through the CEC Controller:
1. Access the CEC Controller using the procedures in “ To run the CEC Controller: ” on
page 370.
2. Select the acknowledgement test you wish to run.
The table below describes the checkbox fields of the Enable Acks portion of the CEC
Controller dialog box.
Refer to the screen shot below which shows enabling the disabling acknowledgement
on the received broadcast header byte:
L
Setting Function
Directed header Sets whether or not incoming directed header bits
are not acknowledged
Directed data Sets whether or not incoming directed data bits
are not acknowledged
Broadcast header Sets whether or not incoming broadcast header
bits are not acknowledged
Broadcast data Sets whether or not incoming broadcast data bits
are not acknowledged