Quantum Data 881 - Manual (Page 239)

881/882 Video Test Generator User Guide (Rev A.22) 221
Viewing the test sequence list
You can view the list of test sequences stored in the generator using the generator front
panel controls or the command line interface.
Viewing the test sequence list using the front panel
Use the following procedure to view the test sequence list using the generator’s front
panel.
To view the sequence list using the front panel:
1. Press the Tools key. The Tools menu appears as shown below:
2. Choose the Sequence item by pressing the adjacent softsoft key.
A list of sequences appears as shown below. If necessary, press the - key to scroll down
the list.
Viewing the test sequence list using the command line interface
Use the following procedure to view the test sequence list using the command line
interface.
To view the sequence list using the command line interface:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN. See “ Establishing a terminal session with
the generator ” on page 31 or “ Establishing a Telnet session with the generator ” on page
34.
2. Set the sequence path to the medium and location you want to query. For example, if
you want to view the sequence files in the generator’s flash memory, enter the following
command:
System
Sequence
Probe
AFC
Probe
NewSeq Analog
Myseq_01 Myseq_02
Myseq_03
Myseq_04
Myseq_05 Myseq_06