Quantum Data 881 - Manual (Page 625)

881/882 Video Test Generator User Guide (Rev A.22) 607
7. Press the Tools key and choose the Reports item by pressing the adjacent soft key.
The following is displayed on the generator’s LCD.
8. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
9. Select EditPCP to define the capabilities of the HDCP device under test.
The following is displayed on the generator’s LCD.
The following table describes the test parameters and their settings (gray = N/A).
Parameter Explanation
DUT type Specifies the type of device under test. This can be one
of Sink, Source, Repeater, Repeater3AB, or
Repeater3C. For this test, select Source.
Source Max KSV Specifies the maximum number of KSVs the source can
read. The valid values are 1 through 127.
Source Authentication Control Specifies the number of times a source DUT attempts
authentication before transitioning into the authentica-
tion state. The valid values are 1 or greater.
Source Out Only Repeater Indicates whether the DUT outputs contents to a
repeater to which no downstream device is connected.
The values are + for yes and - for no.
Sink 1.1 Features Supported Indicates whether the DUT supports Advanced_Cipher
mode and Enhanced Link Verification. The values are +
for yes and - for no.
Sink 1.1 Audio Supported Indicates whether the DUT supports audio output. The
values are + for yes and - for no.
Repeater 1.1 Features Supported Indicates whether supports Advanced_Cipher mode
and Enhanced Link Verification. The values are + for yes
and - for no.
EDID Packets
Misc HDCP
!CompRpt EditPCP
Source :DUT Type
0
1
+Source_Out_OnlyRep :Source_Authe_Cnt
:Source_Max_KSV