Testing hdmi audio – Quantum Data 881 User Manual

Page 349

Advertising

881/882 Video Test Generator User Guide (Rev A.22)

331

Testing HDMI audio

This section provides steps on how to test handling of audio packets by an HDMI display.
Testing can be performed using audio originating from both internal (generator) and
external sources. The generator supports both 2-channel SPDIF audio from internal
source and external source and up to 8-channel audio from an internal audio source.
There are separate sets of images for testing 2-channel SPDIF audio and 8-channel
audio.

The procedures describe how you can vary the audio amplitude, audio frequency and
audio sampling rate for 2-channel or 8-channel audio. Note that there are some limitations
for the 8-channel audio at high sampling rates these are described below.

Testing 2-channel HDMI audio output from internal SPDIF source

To support testing of HDMI audio, the generator provides two-channel LPCM audio (using
an internally-generated sinewave) at the highest audio sampling rate (48 kHz). Multiple
scenarios are provided that allow you to test one or both audio channels at different
amplitudes and frequencies, as well as test using the different supported sampling rates.
The sampling rate for all channels is completed through a single image (AudioRAT).

The following table lists the images used to perform HDMI audio testing using an internal
audio source.

To test an HDMI display using HDMI audio from the generator:

1. Set up the generator for HDMI output. See “

Setting up the generator for HDMI testing

”

on page 302.

2. Press the

Source key and select the first test format (either DMT0660 or 480i2x29).

Alternatively, to select the format using the command line interface, enter the following
commands:

FMTP

/tffs0/Library/Formats // Set format path to generator memory

FMTL