Quantum Data 881 - Manual (Page 1225)

881/882 Video Test Generator User Guide (Rev A.22) AOY
2111 Invalid digital audio signal type
The value specified for digital audio signal type (DAST) is out of range.
2112 Invalid audio digital signal interface
The value specified for digital audio signal interface (DASI) is out of range.
2113 Invalid number of audio channels available
2114 Invalid audio level shift value
The value specified for digital audio level shift (DALS) is out of range.
2115 Invalid audio sine wave rate
The value specified for digital audio sine wave rate (SRAT) is out of range.
2117 Fs measured is not equal to Fs assigned
The value detected for the sampling frequency is not equal to the value assigned for the
audio sampling rate (ARAT). This typically means there is a hardware problem in the
generator’s digital audio generator.
2118 Invalid audio signal amplitude
The value specified by digital audio sine wave amplitude (SAMP) is out of range.
2119 Send CP info error is not zero
The CP infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
2120 Send AVI info error is not zero
The AVI infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
2121 Send SPD info error is not zero
The SPD infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
2122 Send AUD info error is not zero
The AUD infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.
2123 Send MPEG info error is not zero
The MPEG infoframe register on the transmitter is not set to zero and the infoframe is not
transmitted. This typically means that there is a hardware problem in the HDMI board.