Quantum Data 881 - Manual (Page 300)

282 Chapter 9 Analyzing Digital Sources and Cables
To run the Signal Analysis Module from the web server:
1. Open a Web browser (such as Internet Explorer) and type the generator’s IP address
in the address entry field. For example, enter the following: http://206.135.215.189/.
The generator home page appears in the browser.
2. Click on SAM+ (Signal Analysis Module).
The Signal Analysis Module main page appears as a separate application window as
shown below:
Measuring Timing with the Signal Analysis Module
This subsection provides procedures on measuring timing with the Signal Analysis
Module. When measuring timing the application will measure the timing parameters and
identify the format within the 882’s default format library that most closely matches the
values measured. It will then display that format and compare the measured timing values
with the timing values of the identified standard format. A Pass/Fail indication is provided
on the right-most field. The Pass/Fail determination is made by comparing the measured
values from the source with expected values from the default format.