Quantum Data 881 - Manual (Page 259)

881/882 Video Test Generator User Guide (Rev A.22) 241
2. Activate the HDMI-H interface on the output port:
a. Press the Interface key to access the list of interfaces. A listing of signal interfaces
appears on the generator’s display as shown below.
b. Choose the HDMI-H or HDMI-D item by pressing the adjacent soft key. The
interface is activated and the port outputs the currently selected image and format.
c. Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 4 // Selects the HDMI-H interface
ALLU // Applies the interface setting to the generator
3. Press the Interface key repeatedly until the following menu appears:
4. Choose the connector to which the transmit device is connected by pressing the
adjacent soft key.
5. Monitor the HDMI 1.3 deep color video signal received on the HDMI IN connector by
connecting an HDMI cable from the HDMI Tx output (either Tx 1 or Tx 2) to an HDMI
display. (Ideally, the HDMI display should support the resolution of the incoming video.)
VGA
HDMI-D CVBS
S-VIDEO
SDI
*
HDMI-H
VGA
HDMI-D CVBS
S-VIDEO
SDI *HDMI-H
HDMI IN 1
HDMI IN 2 *