Quantum Data 881 User Manual
Page 233
881/882 Video Test Generator User Guide
(Rev A.22)
215
To enable catalogs in the Content list using the front panel:
1. Press the
Content key. The list of images appears on the generator’s
display.
2. Press the
Options key repeatedly until the Library folder appears
on the generator’s display as shown below:
3. Choose the
Library item by pressing the adjacent soft key. The image library
appears as shown below. Each item in the image library is an image catalog.
4. Press the soft key adjacent to a catalog to enable or disable it. A + sign next to the item indicates
the item is enabled; a - sign indicates it is disabled.
5. Press the
Content key to see the images in the selected catalogs.
To remove an image from a catalog:
1. Establish a session with the generator using either HyperTerminal over a serial
connection or Telnet over an Ethernet LAN.see “
Establishing a terminal session with
” on page 31 or “
Establishing a Telnet session with the generator
2. To remove an image from a catalog, enter the following commands:
DIRL /tffs0/Library/ImageLib/TVImages // loads the TVImages catalog
ContentLib
// identifies directory as a content directory
// begins a directory editing session
/cache0/Library/Images/TVImages/SMPTE133.img
Or...
1
// deletes SMPTE133 (index 1)
// ends the directory editing session
// saves the catalog
Library
-TVImages
FPDImages-
SMPTE133 SMPTEBar
TVBar100 PulseBar
Regulate Geom_1