Quantum Data 881 - Manual (Page 624)

606 Chapter 18 Testing HDCP
3. Activate the HDMI-H interface on the output port as follows:
a. Press the Interface key. A listing of signal interfaces appears on the generator’s
display as shown below.
b. Choose the HDMI-H item by pressing the adjacent soft key. The interface is
activated and the display is shown below.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
XVSI 4 // Activates the HDMI-H interface
ALLU // Applies the interface setting to the generator
4. Press the Interface key repeatedly until the following menu appears:
5. Choose the HDMI IN 1 by pressing the adjacent soft key.
6. For the 882E when using the EST, verify that the source is sending in video using the
timing measurement function of the analzyer. Refer to “ To view timing information of an
external HDMI/DVI source signal on a display: ” on page 246 for information on running
the timing test.
Verify that the source is outputting one of the following formats:
• 640x480p at 59.94/60Hz
• 720x480p at 59.94/60Hz
• 720x576p at 50Hz
If the 882 cannot detect the incoming video, enter the following command to turn on the
EST:
QD:PROD:EST // Turns on the EST.
VGA
HDMI-D CVBS
S-VIDEO
SDI
*
HDMI-H
VGA
HDMI-D CVBS
S-VIDEO
SDI *HDMI-H
HDMI IN 1
HDMI IN 2 *