Testing edid for hdmi compliance in, Display (sink) devices – Quantum Data 881 User Manual
Page 543
881/882 Video Test Generator User Guide
(Rev A.22)
525
Testing EDID for HDMI compliance in display (sink) devices
The generator supports the following EDID and video HDMI compliance tests in
accordance with the HDMI Compliance Test Specification 1.3 (CTS):
•
Test ID 8-1: EDID Readable
•
Test ID 8-2: EDID VESA Structure
•
Test ID 8-3: CEA Timing Extension Structure
•
Test ID 8-17: 861B Format Support Requirements
•
Test ID 8-18: HDMI Format Support Requirements
•
Test ID 8-19: Pixel Encoding Requirements
•
Test ID 8-20: Video Format Timing
These tests are intended for in-house testing of products before submission to an HDMI
ATC for full certification testing.
Note: This feature is not supported on the 881 generator.
HDMI sink compliance testing is conducted through the generator’s HDMI OUT connector.
A standard HDMI-to-HDMI cable connects the device under test to the generator. The
generator must be configured to output HDMI signals.
After making the physical connections, you must specify the capabilities of the sink display
under test, which are based on the Capabilities Declaration Form (Appendix 3) of the
Compliance Test Specification. This enables the generator to compare the expected
results with the actual results measured from the display.
Setting up generator for HDMI sink device EDID compliance testing
Follow these procedures to set up the generator for HDMI sink testing for EDID
compliance.
To set up the generator for HDMI sink EDID compliance testing:
1. Connect an HDMI-to-HDMI cable between the HDMI OUT connector on the generator
and the HDMI connector on the display under test.
2. Press the
Source key and choose a valid HDMI format (for example, DMT0660) by
pressing the adjacent soft key.
Alternatively, to select the format through the command line interface, enter the
following command:
DMT0660