Quantum Data 881 - Manual (Page 332)

314 Chapter 10 Testing HDMI Sink Devices
Refer to the image and table below to better understand the configuration and use of this
image.
The following table describes the parameters of the Image Control Tool.
Function/Field Function
Color 1 These slide bars set the beginning color component and grayscale
level (left most value) of the top and bottom ramps. This is expressed
as a percentage of the total range defined by the setting of Number of
Bits per Component (NBPC) from 0% to 100%. For example, if NBPC
is 12 the total range is 4096 with a full gamut setting. Note that the
882E can only display up to 512 colors simultaneously for each ramp
on this RampDif image (if PELD = 32).
Color 2 These slide bars set the ending color component and grayscale level
(right most value) of the top and bottom ramps. This is expressed as a
percentage of the total range defined by the setting of Number of Bits
per Component (NBPC) from 0% to 100%. For example, if NBPC is 12
the total range is 4096 with a full gamut setting. Note that the 882E can
only display up to 512 colors simultaneously for this RampDif image (if
PELD = 32).