Testing dvi displays with hdcp – Quantum Data 881 User Manual
Page 605
881/882 Video Test Generator User Guide
(Rev A.22)
587
Testing DVI displays with HDCP
This section describes how to test DVI and HDMI receivers with HDCP.
To set up the generator for testing a DVI display:
1. Connect an HDMI-to-DVI converter cable between the HDMI OUT connector on the
generator and the device’s DVI receiver.
2. Activate the HDMI-D interface on the output port as follows:
a. Press the
Interface key. A listing of signal interfaces appears on the generator’s
display as shown below.
b. Choose the
HDMI-D item by pressing the adjacent soft key. The interface is
activated, and the port outputs the currently selected image and format.
Alternatively, to activate the interface through the command line interface, enter the
following commands:
3
// Activates the HDMI-D interface
// Applies the interface setting to the generator
3. Choose a standard format (for example, DMT0660) by pressing the adjacent soft key.
Alternatively, you can load the format with the following command:
DMT0660
VGA
HDMI-D
CVBS
S-VIDEO
SDI
*
HDMI-H