Setting up the generator for displayport testing – Quantum Data 881 User Manual
Page 463
881/882 Video Test Generator User Guide (Rev A.22)
445
Setting up the generator for DisplayPort testing
This section provides general procedures for setting up the generator for DisplayPort
testing. The procedures below can be performed using the front panel or the command
line interface.
To set up the generator for DisplayPort testing:
1. Connect a DisplayPort-to-DisplayPort cable between the DisplayPort sink device under
test and the DisplayPort OUT connector on the generator.
2. Press the
Interface key.
3. Activate the DisplayPort interface on the output port by selecting the
DisplayPort item
with the adjacent soft key
Alternatively, to select the interface through the command line, enter the following
commands:
10
// Selects the DisplayPort interface
// Applies the interface setting to the generator
To verify the test set-up:
1. Press the
Source key to access the list of formats.
2. Choose a standard format (for example, DMT0660) by pressing the adjacent soft key.
Alternatively, you can load the format with the following command:
DMT0660
3. Press the
Content key to access the list of images.
4. Choose a suitable image (for example, ColorBar) by pressing the adjacent soft key.
Alternatively, you can load the image with the following command:
ColorBar
5. Verify that the image appears on the display under test.
DispPort*