Sending commands interactively, Common commands – Quantum Data 881 User Manual
Page 53
881/882 Video Test Generator User Guide (Rev A.22)
35
telnet
generatorIPaddress
Example:
telnet 192.168.254.220
2. The /tffs0> prompt appears. Type commands at the /tffs0> prompt, and press
Enter after each command.
Sending commands interactively
This section describes how to send commands through an interactive command line
interface session. The generator parses command lines one at a time. Command lines
must be terminated with a carriage return (<cr>). The generator immediately echoes each
character as it is received and places it in a command line buffer. Commands are not case
sensitive.
When sending multiple commands at once, separate each command with a semi-colon.
For example, to load the 480p59 format with the SMTPEbar image, send the following
commands:
480p59
SMPTEbar
Common commands
•
To apply an image and format to the generator hardware, enter:
•
To display the name of the format currently in the format buffer, enter:
?
•
To load a format, enter:
format_name
•
To apply the format to the generator hardware, enter:
•
To load an image, enter:
image_name
•
To apply the image to the generator hardware, enter: